27
OPERATION
Adjust the height of the tool (Fig. H)
1. Loosen the lower half of the knob located in the middle of aluminum shaft by turning it anti-
clockwise.
2. Pull the lower shaft up or down to adjust the desired height.
3. Tighten the knob by turning counter clockwise.
Switching on and off
To switch on (Fig. I)
1. Hold the product firmly in both hands.
2. To switch on the product, Push the safety button forward with your thumb, and hold it
in place, then press the switch trigger.
To switch off
Release the switch trigger.
WARNING
: The tool runs on for several seconds after it has been switched off.
NOTE
: Always switch off before placing it down.
NOTE
: Do not carry the tool by the main switch.
Install the wire brush
1. In order to uninstall the nylon brush. Insert a pin into the recess on the shaft and hold with
one hand. Loosen the nut by the other hand. (Fig. J&K)
2. Fit the wire brush onto the drive axle, pre-tighten the nut by hand. Make sure the brush fits
accurately into the mount. (Fig. L)
3. The shaft must be fixed in order to fasten the brush. Insert a pin into the recess on the
shaft and hold with one hand. Tighten the nut by the other hand. (Fig. M)
Summary of Contents for LU C10
Page 3: ...3 A B 1 2 3 4 5 6 7 8 a b c d e f ...
Page 4: ...4 C G E I D H F J 1 2 1 2 1 2 ...
Page 5: ...5 K M O L ...