![background image](http://html1.mh-extra.com/html/yard-force/lu-c10/lu-c10_original-instructions-manual_905769028.webp)
28
MAINTENANCE AND STORAGE
WARNING
: Before performing any repair work, always remove the battery pack .
Cleaning
1. Do not spray the unit with water. Water ingress may destroy the battery pack and
the electric motor.
2. Clean the unit with a cloth, hand brush, etc.
3. Keep all nuts, bolts and screws tight to be sure the equipment is in safe working
condition;
4. Replace worn or damaged parts for safety.
Cleaning the Working Tool
WARNING!
Wear safety gloves when working on or near the working tool. Use appropriate
tools (e.g a wooden stick) when necessary; never use your bare hands!
1. All nuts and bolts must be checked periodically for tightness before operation. After
prolonged use, especially in sandy soil conditions, the working tool will become worn and
lose some of its original shape. Weeding efficiency will be reduced and the working tool
should be replaced.
2. Have worn or damaged working parts replaced with new ones of the same type by a
qualified technician.
WARNING!
Unexpected blade movement may cause personal injury. Before servicing,
repairing, or inspecting the unit, turn the motor OFF and remove the battery. Wait for the
blades to completely stop rotating before conducting inspection, cleaning, or maintenance.
Before and after each use, check the product and accessories (or attachments) for wear and
damage. When necessary, only use identical replacement parts that are approved by the
manufacturer.
WARNING!
Contact with hot components (e.g. motor housing, gear box, etc.) on the machine
may cause burns.
Allow the machine to cool off before handling.
IMPORTANT!
• Wear protective gloves when cleaning or maintaining the machine.
• Do not use cleaning fluids or solvents or spray the machine down with water (especially
water under pressure) when cleaning the machine.
NOTE:
After each use, follow these steps to properly clean the unit:
1. Remove soil, dirt, and foliage stuck in the blades, drive shaft, tool surface, and vents with a
brush or dry cloth.
2. Clean soiled grips with a damp cloth.
Always inspect the machine for damaged and worn parts after each use. Check that safety
features (i.e. labels, guards, etc.) are in place. Check that nuts, bolts, and screws are tight.
Summary of Contents for LU C10
Page 3: ...3 A B 1 2 3 4 5 6 7 8 a b c d e f ...
Page 4: ...4 C G E I D H F J 1 2 1 2 1 2 ...
Page 5: ...5 K M O L ...