Yard force LH G40, Original Instruction

Page: 11 / 14

20 21
DESCRIPTION OF PRODUCT
Parts description (Fig. A)
1. Blade
2. Safety button
3. Battery pack release button
4. ON/OFF trigger
5. Rear handle rotary lever
6. Auxiliary handle
Delivery contents (Fig. B)
Carefully unpack the appliance and check that it is complete. Dispose of the packaging
material correctly.
a. Blade shield
b. Hedge trimmer
c. Instrcution manual
d. Charger
e. Battery pack
WARNING: If any parts are damaged or missing, do not operate this tool until these
parts are replaced. Failure to heed this warning could result in serious personal
injury.
NOTE: Always recycle the packaging in accordance with local recycling guidelines.
OPERATION
Charging the battery pack
NOTE: Remove the battery pack from the charger after it has been fully charged.
NOTE: Battery should be fully charged before first use.
NOTE: Make sure the mains voltage is the same as rating label which is located on the
charger.
1. Connect the charger to a power supply. Red LED will light up.
2. To insert the battery pack into the charger, align the raised ribs of the battery pack with
the grooves of the charger then push it in. (Fig. C)
3. The red LED light of the charger will OFF and then the green light flashes during normal
charging.
4. After charging is complete, the charger light will turn to a solid green light.
Power indicator (Fig. D)
This Li-Ion battery pack is equipped with a power indicator which is used to show the battery
pack’s remaining charge. Press the power indicator button to check battery charge as picture
showed. The indicator will stay lit for approximately 4 seconds.
To obtain the best life from the battery
1. Never allow the battery to completely discharge before recharging. The battery pack
should be placed on the charger whenever the battery pack is noticeably running down
or the tool no longer performs a task it previously performed.
2. Avoid conducting short charges. Make sure that the battery is fully charged each time by
allowing the charger to complete its full charging cycle.
3. Avoid allowing loose items like screws or nails etc. to be stored with battery packs as
these or similar items can short battery packs and cause a fire or explosion.
4. Always unplug the charger when not in use and store in a dry and secure place.
5. Avoid charging or storing your battery in temperatures below 5°C and above 45°C.
6. After use, allow the battery pack to cool down for approximately 30 minutes before
attempting to recharge.
Remove the blade cover (Fig. E)
To insert the battery pack (Fig. F)
1. Align the groove on the battery pack with the corresponding ribs in the receptacle of the
device.
2. Insert the battery pack with moderate force until it was locks in to place.
WARNING:
Only use Yard force 40V original battery pack!
To remove the battery pack from the tool (Fig. G)
1. Press once release to transport position
2. Press again full releases the battery
3. Remove the battery pack from the tool.