10
11
OPERATION
Attachment
About packaging used requires your machine is not completely assembled.
•
Mount the feeder brushes to the intended axis and fasten it with 3 screws (b).
•
Attach the lower part of the push handle to the designated assembly points with the
clamping thumb-screw on both sides.
•
Attach the upper part of the push handle (2) as shown in Figure 6.
MAINTENANCE AND STORAGE
Operation
When the sweeper is moved, the feeder brushes (7) and sweeping brushes (9) start rotating,
helped by the belt drive. Rotating feeder brushes (7) drive the dirt to the centre. It is then
collected by sweeping brush and taken to the dirt collecting container (5).
Emptying the dirt collecting container
If you want to take out the dirt collecting container to empty it, take it by its handle and pull
up.
Maintenance
Use a wet cloth for plastic parts cleaning. Do not use any cleaning agents, solvents or sharp
objects. After every use - Remove the appliance off dust and dirt.
If the brush is not rotating it can be that the storage of the brushes is dirty or the belt isn´t
good. Clean and lubricate the bearing of the brush or replace the belt
.
Service information
Please note that the following parts of this product are subject to normal or natural wear
and that the fol
l
owing parts are therefore also required for use as consumables.
Wear parts*: Brushes, drive belts, wheels
*
Not necessarily included in the scope of delivery!
Storage
For any longer storage the appliance must be thor-oughly cleaned and stored so as
unauthorised per-sons could not access it.
•
Empty the dirt collecting container
•
Adjust the brushes to relieve them
•
Store the appliance when it is dry
To save spaces, the sliding handle can be folded. Loosen the screws, pull the sliding handle
out and fold forward.
b
7
3
2
3
4
4
c
