19
OPERATION
Charging the battery Pack (Fig 7)
NOTE:
The battery pack will be fully charged after 70mins. Remove it from the
charger after it has been fully charged.
NOTE:
This battery pack has been shipped in a low charge condition. It should be
fully charged before first use.
NOTE:
Make sure the main voltage is the same as rating label which located on the
charger.
1. Connect the charger to a power supply. The green LED power light comes on,
indicating the charger is ready for use.
2. Align the raised ribs of the battery pack with the slot in the charger. Insert the battery
pack into the charger. The red LED light will come on, and the green LED light will
shut off at the same time, indicating the battery is correctly seated and on charge.
Battery pack
Charger
Fig.7
NOTE:
If the red LED light doesn’t comes on, and the green LED light is still on, the
battery
pack is too hot and cannot be charged.
Remove the battery and allow it to cool for 30 minutes and then re-insert it.
3. The battery pack will normally be fully charged after 70 minutes, when the red LED
light will shut off and the green light comes on again. The initial charge may take
longer.
4. Remove the battery pack from the charger.
To obtain the best life from the battery
Never allow the battery to completely discharge before recharging. The battery pack
should be placed on the charger whenever the battery pack is noticeably running down or
the tool no longer performs a task it previously performed.
Summary of Contents for GDGS12
Page 2: ...2 ...
