YCO-1111-03-13
DP-6200
Operation Manual
8
Setting the Over/Under Indicator
1) Place the scale in normal weighing mode.
2) Press and hold the
ON
key and push the
NET
GROSS
key (yellow
tabs).
3) Press the
ON
key to select the digit you want to change. The
flashing underscore will advance to the right.
4) Press the up and down arrows to select the desired value.
5) Repeat steps 3 and 4 until all digits are set. All values below
this setpoint will be indicated as under.
6) Press and hold the
ON
key and push the
NET
GROSS
key (yellow
tabs). This saves the lower limit and moves to the upper limit.
7) Press the
ON
key to select the digit you want to change.
8) Press the up and down arrows to select the desired value.
9) Repeat steps 7 and 8 until all digits are set. All values above
this setpoint will be indicated as over.
10) Press and hold the
ON
key and push the
NET
GROSS
key (yellow
tabs). This saves the upper limit and returns the scale to nor-
mal weighing mode.
To disable the Over/Under indicator, set both setpoints to zero.
IV Directions for Use
lb
lb
lb
lb
lb
lb
lb
lb
lb
lb
