YAMARIN Cross 75 Bow Rider, User Manual

Page: 37 / 42

37 (42)
7.2 Measures before launching the boat
Repair any damage to the gelcoat surface according to section 6.10.
In sea areas, antifouling paint should be used to prevent the hull from becoming covered
with vegetation. Fouling of the bottom and especially the propeller increases fuel
consumption remarkably. However, if the boat is anchored at the inlet of a stream or in a
land-locked lake, or if it is lifted out of the water at least once every two weeks, it is normally
not necessary to use antifouling paint. Carefully follow the paint man
ufacturer’s instructions
when applying the paint. When sanding old antifouling paint, remember that the dust is
toxic. Antifouling paint is not necessary in fresh water (lake areas).
NOTE! Do not apply any paint to the zinc anodes, depth finder sensor, or
piston rods of the hydraulic trim tabs. Do not apply paints
containing copper or lead on aluminium parts. and remember to
follow the paint manufacturer’s instructions. The warranty does
not cover damage caused to the hull by antifouling paint
containing lead or copper.
Useful tip:
Do not throw away a used paint brush. A dried and hardened
paint brush that has been used for antifouling paint can be reused
if you first soak it for a couple of hours in a mix of 2 litres of hot
water, 100 ml of vinegar, and 50 ml of baking powder.
Perform the necessary service procedures required for the engine according to the engine
manual. Check the functioning of electric equipment and remove any oxidation from fuse
connectors etc.
Remember that petrol goes stale over time, and you must always start the engine with fresh
petrol in the spring.
When the boat has been launched you should open all hull bushings and check to ensure
that there are no leaking hoses or connectors. The locations of bushings (through fittings)
are shown in section 5. Bring your safety equipment back on board before setting out.