Yamaha YZF-R1LEVC, Supplementary Service Manual

Page: 26 / 87

SPEC
18
Clamp the fuel tank drain hose
and fuel tank breather hose.
Route the lead by the inside of
the water hose and water pipe.
Route the lead by the inside of
the water hose and water pipe.
There should be no exposure of
bared conductors due to the
displacement of the tube.
Route by the outside of vehicle
away from the water hose.
Point the tip of the clamp
(excessive part) to the down
rear side of the vehicle. Fasten
the wire harness with a clamp.
The outside of the vehicle. Inner most section of the vehi-
cle.
Can be routed in any order.
Route the water hose so that it is
placed at the outermost position
finally after routing other leads
and hoses in the guide.
Route the coolant reservoir tank
drain hose so that it is routed at
the innermost position to each
hose and lead.
Arrange so as not for each hose
to cross in the part between
“BB” from the section “AA”
which is in the illustration. Align the molded part of the fuel
tank drain hose with the stay 1.
Routing of the fuel tank drain
hose.
EXUP servo motor, oil level
switch and sidestand switch
leads are omitted in this drawing.
CABLE ROUTING