Yamaha YZF-R1LEVC, Supplementary Service Manual

Page: 28 / 87

SPEC
20
Pass the wire harness through
the clamp inserted to the radia-
tor stay.
To the headlight lead
Clamp the lead between three
protrusions of the pipe (the first
and second parts from the vehi-
cle front). Point the tip of the
clamp (excessive part) to the
inside of the vehicle.
To the vehicle right side diagram
To the engine
Clamp the lead between three
protrusions of the pipe (the
inside and outside of the vehi-
cle). Point the tip of the clamp
(excessive part) to the inside of
the vehicle.
All hoses and leads should be
routed over the vehicle’s upper
side above the heat protector.
To the starter motor
Fasten the wire harness, clank
shaft position sensor lead, rear
brake light switch lead and
speed sensor lead with a clamp.
Then, point the tip of the clamp
(cut the tip of the clamp leaving
2 to 4 mm (0.08 to 0.16 in).) to
the inside of the vehicle. Pass the water hose lower side
of the thermostat, and between
the ground lead and the neutral
switch.
Install the leads so that the
engine ground lead is posi-
tioned lower and the battery
negative lead to be upper.
Install the protrusion of each
lead to be above the vehicle.
Route the crankshaft position
sensor lead under the wire har-
ness.
To the fuel pump
Clamp the wire harness winding
in and insert it to the frame hole.
CABLE ROUTING