Yamaha YZF-R125, Service Manual, Page: 116 / 356

FRONT WHEEL
4-11
3. Lubricate:
• Front wheel axle
• Oil seal lip
• Speed sensor lip
4. Install:
• Speed sensor
NOTE:
Make sure the speed sensor and the wheel hub
are installed with the two projections meshed
into the two slots respectively.
5. Install:
• Front wheel
NOTE:
Make sure the stopper “a” in the speed sensor
fits over the slot “b” on the outer tube.
6. Tighten:
• Front wheel axle
• Front wheel axle pinch bolt
WARNING
EWA5D71009
Make sure the brake hose is routed properly.
CAUTION:
ECA5D71028
Before tightening the wheel axle, push down
hard on the handlebar(s) several times and
check if the front fork rebounds smoothly.
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Insert the front wheel axle from the right side
and tighten it from the left side to 59 Nm (5.9
m·kg, 43 ft·lb) without performing temporary
tightening.
b. Tighten the front wheel axle pinch bolt to 14
Nm (1.4 m·kg, 10 ft·lb) without performing
temporary tightening.
c. Check that the right end of the front wheel
axle is flush with the front fork. If necessary,
manually push the front wheel axle or lightly
tap it with a soft hammer until its end is flush
with the front fork. However, if the surface of
the front wheel axle end is not parallel to the
surface of the front fork, align a point on the
outer edge of the axle with the fork, making
sure that the axle does not protrude past the
fork.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
Recommended lubricant
Lithium-soap-based grease
T
R
.
.
Front wheel axle
59 Nm (5.9 m·kg, 43 ft·lb)
Front wheel axle pinch bolt
14 Nm (1.4 m·kg, 10 ft·lb)
b
a
YamahaR125.COM