Transaxle Oil
To check transaxle oil level:
1. Place the utility vehicle on a flat,
level surface and turn the main
switch to the “OFF” position.
2. Remove seven plastic rivets
1
and two bolts
2
, and remove
the bag holder insert
3
.
3. Place an oil pan under the
transaxle case.
4. Clean area around servicing plug
4
.
5. Using an 8 mm hex wrench,
remove transaxle oil servicing
plug located on the rear of the
transaxle case.
6. Transaxle oil should be at the top
of the oil servicing hole or just
beginning to run out of hole.
Do not allow foreign material to
enter transaxle. Serious transaxle
damage can result.
7.
If needed, add Yamalube
Friction Modified Shaft Drive
Gear Oil until it is at the top of
the plug hole or just beginning to
run out of servicing hole.
TIP
The utility vehicle is equipped with
an internal wet brake. Use of oil
other than Yamalube Friction
Modified Shaft Drive Gear Oil will
cause brake noise.
8.
Install the transaxle servicing
plug and tighten to 14-19 Nm,
1.4-1.9 m•kg (120-168 in•lbs).
NOTICE
JW7
7-10
MAINTENANCE
1
2
3
4
5
6
7
8
9
10
11
4
Y-1214
1
2
3
Y-1994
JW7-F8199-22_LIT_19626_16_05.qxd 5/9/13 4:28 PM Page 45