8-14
8
Before installing the spark plug, the spark plug
gap should be measured with a wire thickness
gauge and, if necessary, adjusted to specification.
Clean the surface of the spark plug gasket and its
mating surface, and then wipe off any grime from
the spark plug threads.
TIP
If a torque wrench is not available when installing
the spark plug, a good estimate of the correct
torque is 1/4–1/2 turn past finger tight. However,
the spark plug should be tightened to the speci-
fied torque as soon as possible.
EBU2949B
Engine oil and oil filter element
The engine oil level should be checked before
each ride. In addition, the oil must be changed and
the oil filter element replaced at the intervals spec-
ified in the periodic maintenance and lubrication
chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Start the engine, warm it up until the engine
oil has reached a normal temperature of 60
°C (140 °F), let it continue to idle for ten sec-
onds or more, and then turn the engine off.
Specified spark plug:
NGK/CR8E
1. Spark plug gap
Spark plug gap:
0.7–0.8 mm (0.028–0.031 in)
Tightening torque:
Spark plug:
13 N·m (1.3 kgf·m, 9.6 lb·ft)
UBW261E0.book Page 14 Friday, May 26, 2017 9:38 AM
Summary of Contents for YFZ450R 2017
Page 48: ...4 24 4 1 Handlebar 1 UBW261E0 book Page 24 Friday May 26 2017 9 38 AM ...
Page 63: ...7 1 7 EBU21142 RIDING YOUR ATV UBW261E0 book Page 1 Friday May 26 2017 9 38 AM ...
Page 146: ...11 2 11 1 Model label 1 UBW261E0 book Page 2 Friday May 26 2017 9 38 AM ...
Page 149: ...UBW261E0 book Page 3 Friday May 26 2017 9 38 AM ...