Yamaha YFM4FAR, Service Manual

Page: 81 / 397

3 - 18
CHK
ADJ
ADJUSTING THE STARTER CABLE
2.Adjust:
*****************************************************
Adjustment steps:
●
Disconnect the starter cable
1
from the
carburetor body.
NOTE:
Do not remove the starter plunger
2
from the
starter cable.
●
Measure the starter plunger stroke distance
a
of the starter lever
3
fully close to fully
open position. If the distance is out of
specification adjust it as described below.
È
Fully closed position
É
Fully open position
●
Pull back the boot
4
.
●
Loosen the locknut
5
.
●
Turn the adjuster
6
in or out until the correct
free play is obtained.
●
Tighten the locknut
5
.
●
Push in the boot
4
.
●
Connect the starter cable to the carburetor.
WARNING
After adjusting the cable, turn the
handlebar to right and left, and make sure
that the engine idling speed does not
increase.
*****************************************************
Starter plunger stroke distance:
15 mm (0.59 in)
Turning in Free play increased.
Turning out Free play decreased.
3.Install:
●
Fuel tank side panel (left)
●
Seat
Refer to “SEAT, CARRIERS, FENDERS
AND FUEL TANK”.