INSTALLING THE INCLUDED PARTS
– 7 –
79
3. Installing the handlebar
Install the handlebar
a
so that the 3rd horizon-
tal line from the top of the alignment mark
b
shown is positioned at the lower end of the hole
in the upper handlebar holder
c
, and then
tighten the 4 bolts
d
of the handlebar holder
c
to the specified torque.
TIP
8
Tighten bolts
d
evenly in stages, in the order
shown in the illustration.
8
Tighten in such a way that the gaps
e
above
and below the handlebar holder
c
are equal.
Install the handlebar
a
so that the brake lever
f
is at a 30
angle to the handlebar, as shown
in the illustration.
4. Adjusting the display unit position
Maintain a clearance of 1 to 2 mm between the
bracket of the display unit
a
and the handlebar
stem
b
as shown, install the set, and then
tighten the bolt
c
to the specified torque.
TIP
Adjust the display unit screen so that it is parallel to
the handlebar stem
b
.
a
c
d
d
b
Tightening tor
qu
e 6 N·m (0.6 kgf·m, 4.4 l
b
·ft)
The handlebar
a
should not touch the frame
when it is turned fully to the left or right.
NOTICE
d
c
e
e
3
0°
a
f
Tightening tor
qu
e
3
.8 N·m (0.
3
8 kgf·m, 2.8 l
b
·ft)
1
〜
2mm
b
a
c
Tightening torque 3.8 N·m (0.38 kgf·m, 2.8 lb·ft)
(0.04–0.08 in)
