Yamaha WR250, Owner'S Service Manual

Page: 148 / 694

2 - 19
SPEC
CABLE ROUTING DIAGRAM
EC240000
CABLE ROUTING DIAGRAM
1 Hose guide
2 Brake hose
3
Voltage regulator
4 Light switch lead
5 Fuel tank breather hose
6 Engine stop switch lead
7 Clamp
8 Oil tank breather hose
9 Sub-wire harness
0 Taillight lead
A Throttle position sensor lead
B Neutral switch lead
C Oil hose
D Cylinder head breather hose
E CDI magneto lead
F Clutch cable
G Cable guide
H Carburetor breather hose
I Carburetor overflow hose
J Coolant reservoir breather hose
K
Decompression cable
L Ground lead
M Ignition coil lead
N CDI unit lead
O Voltage regulator lead
Å
Pass the fuel tank breather hose
behind handlebar, then insert it
into the steering stem hole.
ı
Pass the decompression cable,
engine stop switch lead and light
switch lead under where the oil
hose is attached.
Ç
Pass the voltage regulator lead,
engine stop switch lead and light
switch lead over the radiator
hose.
Î
Fasten the engine stop switch
lead, light switch lead and igni-
tion coil lead of the sub-wire har-
ness.
‰
Fasten the sub-wire harness
and engine stop switch lead.
Ï
Pass the cylinder head breather
hose along the right side of the
oil tank breather hose.
Ì
Fasten the sub-wire harness
and light switch lead in front of
the upper engine brackets.
Ó
Fasten the sub-wire harness.
È
Pass the sub-wire harness
between the upper engine
brackets.
Ô
Fasten the sub-wire harness.

Fasten the throttle position sen-
sor lead.