Yamaha WOLVERINE, Owner'S Manual, Page: 26 / 167

4-4
EBU00053
Handlebar switches
1. Light switch “LIGHTS”
2. Engine stop switch “ENG. STOP”
3. Start switch “START”
EBU00054
Engine stop switch “ENG. STOP”
Make sure that the engine stop switch is in the
“RUN” position. The engine stop switch con-
trols ignition and can be used at all times to
stop the engine, especially in an emergency.
The engine will not start or run when the en-
gine stop switch is turned to “OFF”.
EBU00647
Start switch “START”
The starter motor cranks the engine when this
switch is pushed.
CAUTION:
See the starting instructions on page 6-1
prior to starting the engine.
EBU00734
Light switch “LIGHTS”
Turn the switch to the “LO” position to switch
on the low beam and the taillight.
Turn the switch to the “HI” position to switch
on the high beam and the taillight.
Turn the switch to the “OFF” position to switch
off the headlight and the taillight.
CAUTION:
Do not use the headlight with the engine
turned off for more than thirty minutes.
The battery may discharge to the point
that the starter motor will not operate
properly. If this should happen, remove
the battery and recharge it.
U4KB1C.book Page 4 Wednesday, October 23, 2002 2:54 PM