Maintenance
63
ized filling device, inject the gear oil into
the gear oil drain screw hole.
7.
When the oil begins to flow out of the oil
level plug hole, insert and tighten the oil
level plug.
8.
Insert and tighten the gear oil drain
screw.
9.
Securely install the cooling water inlet
covers on both sides of the gear case
using the bolt and nut removed earlier.
EMU29312
Inspecting and replacing anode(s)
Yamaha outboard motors are protected from
corrosion by sacrificial anodes. Inspect the
external anodes periodically. Remove scales
from the surfaces of the anodes. Consult a
Yamaha dealer for replacement of external
anodes.
CAUTION:
ECM00720
Do not paint anodes, as this would render
them ineffective.
NOTE:
Inspect ground leads attached to external
anodes on equipped models. Consult a
Yamaha dealer for inspection and replace-
ment of internal anodes attached to the pow-
er unit.
EMU29320
Checking battery (for electric start
models)
WARNING
EWM00330
Battery electrolytic fluid is dangerous; it
contains sulfuric acid and therefore is
poisonous and highly caustic.
Always follow these preventive mea-
sures:
●
Avoid bodily contact with electrolytic
fluid as it can cause severe burns or
permanent eye injury.
●
Wear protective eye gear when han-
Recommended gear oil:
Hypoid gear oil SAE#90
Gear oil quantity:
1050.0 cm
3
(35.50 US oz) (37.03
Imp.oz)
ZMU02364
ZMU01901
ZMU01902
Summary of Contents for VZ200
