Maintenance
50
ing Silicon, Phosphorus, or Lead. Con-
sult your Yamaha dealer for details on the
use of chemical goods for storage.
EMU28303
Procedure
EMU31920
Conditioning and stabilizing fuel
Fill the fuel tank with fresh fuel and add one
ounce of “Yamaha Fuel Conditioner and Sta-
bilizer” (Part No. LUB-FUELC-12-00) to each
gallon of fuel.
NOTE:
The use of “Yamaha Fuel Conditioner and
Stabilizer” eliminates the need to drain the
fuel system. Consult your Yamaha dealer or
other qualified mechanic if the fuel system is
to be drained instead.
EMU31900
Engine anti-rust measure
CAUTION:
ECM01530
Do not perform this procedure while the
engine is running. The water pump may
be damaged and severe damage from
overheating can result.
NOTE:
This procedure is performed while the top
cowling is removed.
1.
Remove the spark plug(s).
2.
Pour a teaspoonful of clean engine oil
into each cylinder.
3.
Crank the engine several times manual-
ly.
4.
Reinstall the spark plug(s).
EMU31390
Washing the outboard motor
NOTE:
This procedure is performed while the top
cowling is installed.
1.
Wash the outboard motor body using
fresh water.
2.
Drain the cooling water completely out
of the motor. Clean the body thoroughly.
EMU28410
Lubrication (oil injection models)
1.
Grease the spark plug threads and in-
stall the spark plug(s) and torque to
proper specification. For information on
spark plug installation, see page 56.
2.
Fill the oil tanks. This prevents the for-
mation of condensation. For models with
a remote oil tank, it may be necessary to
manually override the control unit to
completely fill the engine oil tank.
3.
Change the gear oil. For instructions,
see page 62. Inspect the oil for the pres-
ence of water which indicates a leaky
seal. Seal replacement should be per-
formed by an authorized Yamaha dealer
prior to use.
4.
Grease all grease fittings. For further de-
tails, see page 56.
EMU30261
Cleaning and anticorrosion
measures
1.
Wash down the exterior of the outboard
motor with fresh water and dry off com-
pletely.
2.
Spray the outboard motor exterior with
“Yamaha Silicone Protectant” (Part No.
LUB-SILCNE-13-00).
CAUTION:
ECM01401
Do not spray when the engine is running.
Also, do not spray near the silencer or
into the engine. Otherwise the engine
could be damaged.
3.
Wax the cowling with a non-abrasive
wax such as “Yamaha Silicone Wax”
(Part No. ACC-11000-15-02).
Summary of Contents for VZ200
