Yamaha TZ250M1, Owner'S Service Manual

Page: 73 / 287

REAR BRAKE PAD INSPECTION AND REPLACEMENT
3-20
• Install the brake pads
9
, pad support
0
,
pad pin
¡
and cotter pin
™
.
NOTE:
• Always use a new cotter pin.
• Temporarily tighten the pad pin at this
point.
• Install the caliper
£
and tighten the pad
pin
¢
.
™
Bolt (caliper):
35 Nm (3.5 m•kg, 25 ft•lb)
Pad pin:
18 Nm (1.8 m•kg, 13 ft•lb)
3. Inspect:
• Brake fluid level
Refer to “BRAKE FLUID LEVEL INSPEC-
TION” section.
4. Check:
• Brake lever operation
A softy or spongy feeling
≥
Bleed brake
system.
Refer to “BRAKE SYSTEM AIR BLEED-
ING” section.
EC366031
REAR BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
• Brake pad thickness
a
Out of specification
≥
Replace as a set.
Brake pad thickness
a a
:
Standard <Limit>
4.0 mm (0.16 in) 1.0 mm (0.04 in)
{
2. Replace:
• Brake pad
Brake pad replacement steps:
• Loosen the pad pin
1
and remove the
caliper
2
.
NOTE:
Before removing the caliper from the
swingarm, loosen the pad pin.
INSP
ADJ