PERIODIC MAINTENANCE AND MINOR REPAIR
6-32
1
2
3
4
5
6
7
8
9
2. Lift the wheel up between the fork
legs.
NOTE:
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the tripmeter gear unit fits over the re-
tainer on the fork leg.
3. Insert the wheel axle, and then
tighten it to the specified torque.
4. Tighten the wheel axle holder nuts
to the specified torque.
NOTE:
Tighten the upper nuts first, and then
the lower ones. When the nuts are
tightened in this sequence, there
should be a gap at the bottom of the
axle holder.
5. While applying the front brake,
push down hard on the handlebars
several times to check if the front
fork compresses and rebounds
smoothly.
6. Connect the tripmeter cable.
1. Retainer
2. Wheel axle
3. Wheel axle holder nut
Tightening torque:
Wheel axle:
58 Nm (5.8 m·kgf, 42 ft·lbf)
1
2
3
(
×
4
)
1. Upper nut
2. Lower nut
3. Gap
Tightening torque:
Wheel axle holder nut:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1
2
3
Summary of Contents for TTR250V
