Yamaha TT250RA, Owner'S Manual

Page: 72 / 88

PERIODIC MAINTENANCE AND ADJUSTMENT
7-33
1
2
3
4
5
6
7
8
9
according to the procedure on
page 7-32.
4. Pull the wheel axle out, and then
remove the wheel. NOTICE: Do
not apply the brake after the
wheel has been removed to-
gether with the brake disc, oth-
erwise the brake pads will be
forced shut.
[ECA11071]
EAU24950
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
2. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the wheel axle to the spec-
ified torque.
6. Tighten the axle holder nuts to the
specified tightening torque. Tight-
en the upper nuts first and then
lower ones. When tightened in this
sequence, there should be a gap
formed at the bottom of the axle
holder.
7. After tightening the axle holder
nuts, push down hard on the han-
dlebars several times while apply-
ing the front brake to check if the
front fork compresses and re-
1. Speedometer gear unit
1
1. Retainer
Tightening torque:
Wheel axle:
58 Nm (5.8 m·kgf, 42 ft·lbf)
1
1. Upper nut
2. Lower nut
3. Gap
Tightening torque:
Axle holder nut:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1
2
3