Yamaha SY.22, Authorized Product Manual

Page: 52 / 101

ELEMENT TONE
+2 Broader change between medium and hard
velocity.
+3 Smooth change all the way from soft to hard
velocity.
+4 Large change over small velocity range.
+5 Sudden change from no sound to maximum
level at about medium velocity.
"-" Settings have the same effect, but the
sound level decreases rather than increasing
with increased key velocity. A graphic display to
the right of the sensitivity value provides a
visual indication as to the type of change
produced by each setting.
Summary: Determines how the output level of the
selected element changes in response to key-
board after touch pressure changes when the
Lev (Level) parameter of the AFTER TOUCH
function in the VOICE COMMON mode is set
to "on" (see page 33).
Settings:-3 ...0...+3
Procedure: Use the key to move the cursor to
the lower display line. Use the [-1/NO] and
[+1/YES] keys to select the desired after touch
sensitivity.
Details: Plus "+" settings produce higher output
level in response to higher after touch pressure.
Minus "-" settings produce the opposite effect:
lower level in response to higher pressure. A
setting of "0" results in no level variation.
0 No response.
+1 Narrow change between medium-high and
high pressure.
+2 Broader change between medium and high
pressure.
+3 Smooth change all the way from low to high
pressure.
"-" Settings have the same effect, but the
sound level decreases rather than increasing
with increased after touch pressure. A graphic
display to the right of the sensitivity value
provides a visual clue as to the type of change
produced by each setting.
Refer to: AFTER TOUCH, page 33.
Summary: Adjusts the tone of the selected FM
element — B or D.
Settings: Lev (Level): 0 ... 99
FB (Feedback): 0 ... 7
Details: The Lev parameter adjusts the modulation
level of the select FM element, so higher values
produce a brighter, sharper tone while lower
values produce a rounder, more mellow tone.
The effect of the feedback parameter varies from
element to element, but in general higher values
make the sound more brassy or noisy, while
lower values make the sound smoother.
Refer to: WAVE TYPE, page 43.
Procedure: Use the and cursor keys to
place the underline cursor under the Lev or FB
parameter. Use the [-1/NO] and [+1/YES] keys
to set the level or feedback as required.
47