Initializing the STAGEPAS 1K
STAGEPAS 1K Owner’s Manual
17
Initializing the
STAGEPAS 1K
If you want to reset the parameters that were programmed
from STAGEPAS Editor, or reset the Bluetooth pairing
(registering) information to the factory default settings,
follow the steps below:
1.
Turn the power switch off.
2.
While pressing and holding down the
[BLUETOOTH/CONTROL MODE] switch and
[REVERB] switch simultaneously, turn on
the I/O (Power) switch on the rear panel.
While the unit is being initialized, the [POWER] LED,
[BLUETOOTH/CONTROL MODE] LED, and
[BLUETOOTH PAIRING] LED will flash.
3.
When the initialization is complete, the unit
automatically restarts.
After the initialization process, the parameter values
will change as follows:
* Parameters that can be controlled only from STAGEPAS
Editor
Storing the Unit
1.
Install the included, dedicated cover over the
STAGEPAS 1K.
2.
Put the line array speaker and spacers into
the pocket that is marked with the Yamaha
logo.
To move the unit, open the flap on top of the
cover and hold the handle on the unit.
NOTE
For information regarding the DL-SP1K, an optional dolly
designed for use with the unit, please refer to the DL-SP1K
Owner’s Manual.
Parameter
Value
REVERB
Knob position
EQ
REVERB TYPE/TIME
MODE
MONITOR LEVEL
MASTER LEVEL
REVERB ON/OFF
Default (OFF)
STEREO MONO/ST MODE
Default (MONO)
BLUETOOTH CONTROL
MODE
Default (OFF)
Bluetooth audio pairing
(registration) information
All cleared
CHANNEL LEVEL*
Default (0 dB)
CHANNEL ON*
Default (ON)
PAN*
Default (CENTER)
CHANNEL REVERB LEVEL*
Default (ON)
REVERB LEVEL*
Default (–3 dB)
MASTER ON/OFF*
Default (ON)
LABEL*
Default (STAGEPAS 1K)
PRESET*
Values for PRESET #1–8
are cleared.
PASSCODE*
Disabled
