Yamaha Seascooter Scout, User Manual

Page: 14 / 15

24 23
Press here to release and pull to disconnect
Fig.11
Ensure sealing surface is clean and
seal is lubricated
For battery charging follow these instructions.
1. Always ensure that the Safety Lock in the Off position is
Off - see fig. 5b.
2. Always ensure that the SEASCOOTER
™
SEAL /
EXPLORER is out of the water, dry and placed in a dry
area.
3. Pull the latches down and remove the Nose Cone as
shown in fig. 10.
4. Allow two minutes for any gasses to dissipate.
5. Disconnect the battery cable from the housing cable
(if not already disconnected - the cable will be
disconnected when you buy your SEASCOOTER
™
) by
pressing the locking feature, as shown in fig. 11.
6. Remove battery and place on a level surface.
7. Connect the battery cable to the charger cable.
8. Plug charger into mains, and turn on the supply.
9. Charging will take 14-16 hours for a fully discharged
battery. When the battery is charging the red LED is lit,
when the battery is charged the green LED is lit.
10. Disconnect the Charger from the mains.
11. Unplug the battery cable from the charger cable.
12. Allow battery to stand for 30 minutes before using it.
13. When ready for use, place the battery into the housing
and connect the housing cable.
Fig.13
To replace a flat battery with a fully charged battery.
1. Follow the steps 1 to 3 on page 22, to open the
SEASCOOTER
™
.
2. Allow two minutes for gases to dissipate.
3. Unplug the battery at the socket by pressing the locking
feature shown in fig. 11.
4. Remove the flat battery.
5. When ready for use, install and connect battery in the
correct position, see fig. 13.
DO NOT STORE BATTERY IN SEASCOOTER.
14. Make sure the seal and sealing surfaces are clean and fully
lubricated with the supplied grease EVERYTIME (you can
also buy this at your local hardware store) before
replacing the Nose Cone. See fig. 12.
15. Replace the Nose Cone and close the latches.
6. Follow steps 14 to 15 on page 22, to close the
SEASCOOTER
™
.
Buying batteries
Additional batteries can be purchased separately. Contact
your local customer service center/distributor to purchase
them.
Fig.12
SEAL EXPLORER
SEAL EXPLORER
Silicone
Grease