22
For battery charging follow these instructions.
1. Always ensure that the Safety Lock in the Off position is
Off - see fig. 5b.
2. Always ensure that the SEASCOOTER
™
SEAL /
EXPLORER is out of the water, dry and placed in a dry
area.
3. Pull the latches down and remove the Nose Cone as
shown in fig. 10.
4. Allow two minutes for any gasses to dissipate.
5. Disconnect the battery cable from the housing cable
(if not already disconnected - the cable will be
disconnected when you buy your SEASCOOTER
™
) by
pressing the locking feature, as shown in fig. 11.
6. Remove battery and place on a level surface.
7. Connect the battery cable to the charger cable.
8. Plug charger into mains, and turn on the supply.
9. Charging will take 14-16 hours for a fully discharged
battery. When the battery is charging the red LED is lit,
when the battery is charged the green LED is lit.
10. Disconnect the Charger from the mains.
11. Unplug the battery cable from the charger cable.
12. Allow battery to stand for 30 minutes before using it.
13. When ready for use, place the battery into the housing
and connect the housing cable.
Charging the battery for SEAL /EXPLORER
14. Make sure the seal and sealing surfaces are clean and fully
lubricated with the supplied grease EVERYTIME (you can
also buy this at your local hardware store) before
replacing the Nose Cone. See fig. 12.
15. Replace the Nose Cone and close the latches.
Fig.10
Warning!
Replace the battery immediately if it is damaged.
For battery charging follow these instructions.
1. Always ensure that the Master Switch is in the 'Off'
position. (see fig. 4b)
2. Always ensure that the SCOUT is out of the water, dry
and placed in a dry area.
3. Unclip the latches and remove the Nose Cone. (see fig. 6)
4. Allow two minutes for any gasses to dissipate.
5. Disconnect the battery cable from the housing cable
(if not already disconnected - the cable will be
disconnected when you buy your SCOUT ) (see fig. 7)
21
15. Replace the Nose Cone and turn and lock the latches -
you will hear a click when they are locked. (see fig.9)
The SCOUT is now ready to be used.
Replacing a flat battery with a fully charged battery.
1. Follow the steps 1 to 5 above
2. Remove the flat battery.
3. Install the charged battery.
4. Follow steps 13 and 15.
Buying Rechargeable Batteries
It is a good idea to have a second battery so that when
one has run out you can swap it over with a charged
one. Contact your local customer service
center/distributor to purchase additional rechargeable
batteries.
6. Remove the battery from the SCOUT and place on a
level surface.
7. Connect the battery cable to the charger cable.
8. Plug charger into electrical socket / plug, and turn on
the supply.
9. Charging will take 10-12 hours for a fully discharged
battery. When the battery is charging the red LED is on,
when the battery is charged the green LED turns on.
10. Unplug the charger from the mains.
11. Allow battery to stand for 30 minutes before using it.
12. Unplug the battery cable from the charger cable.
13. When ready for use, install battery and reconnect to
the housing cable.
14. Make sure the Nose Cone seal and sealing surfaces
(see fig. 8) are clean and fully lubricated with silicone
grease EVERYTIME (you can buy this at your local
hardware store) before replacing the Nose Cone.
A
B
Fig.9
