Yamaha RX10RTL, Owner'S Manual

Page: 71 / 99

8-18
7. If the position is incorrect, adjust the V-belt position
by removing or adding a spacer 4 on each adjusting
bolt 5 .
CD-06E
8. Tighten the adjusting bolts.
9. Install the V-belt over the primary sheave assembly.
10. Rotate the secondary sliding sheave clockwise 6
and push 7 it so that it separates from the secondary
fixed sheave.
11. Install the V-belt 8 between the secondary sliding
and fixed sheaves.
12. Install the drive guard.
13. Install the left side cover and the shroud.
WARNING
@
Never run the engine with the V-belt or drive guard
removed.
@
V-belt position Adjustment
More than 1.5 mm (0.06 in)
above the edge
Remove spacer
From 1.5 mm (0.06 in)
above the edge to 0.5 mm
(0.02 in) below the edge
Not necessary
(It is correct.)
More than 0.5 mm (0.02 in)
below the edge
Add spacer
Adjusting bolt tightening torque:
10 Nm (1.0 m·kgf, 7.2 ft·lb)
U8FP10.book Page 18 Thursday, April 28, 2005 5:11 PM