Yamaha RX10RTL, Owner'S Manual

Page: 36 / 99

6-4
CAUTION:
@
● When adding the engine oil, be careful not to fill
above the “F” level mark on the oil level
gauge/dipstick.
● Make sure that no foreign material enters the
engine oil tank.
@
7. Insert the oil level gauge/dipstick into the oil filler
hole, and then tighten it securely.
8. Connect the oil level gauge coupler.
9. Install the right side cover and the shroud.
ESU04511
Coolant
Checking the coolant level
1. Remove the top cover. (See pages 8-5–8-7 for
removal procedures.)
2. Check the coolant level in the coolant recovery tank
when the engine is cold. If the coolant level is below
the “COLD LEVEL” mark, add soft water until it
reaches the “COLD LEVEL” mark. (See pages 8-14–
8-16 for more details.)
1
“COLD LEVEL” mark
WARNING
@
Do not remove the coolant reservoir cap when the
engine is hot.
@
2
Coolant reservoir cap
CAUTION:
@
● Hard water or salt water is harmful to the engine
parts. You may use boiled or distilled water, if soft
water is not available.
● Tap water can be used temporarily in an emer-
gency.
@
U8FP10.book Page 4 Thursday, April 28, 2005 5:11 PM