FM/AM tuning
71
En
In
tern
al
So
ur
ce
Op
eratio
n
Use this feature to store the desired FM and AM stations manually.
You can also store up to 40 stations (A1 to E8: 8 preset station
numbers in each of the 5 preset station groups) manually.
1
Tune into the desired station.
See pages 68 and 69 for tuning instructions.
2
Press
J
MEMORY
(or
0
MEMORY
).
The MEMORY indicator flashes in the front panel display for
approximately 10 seconds.
3
Press
M
PROGRAM
(or
9
A-E
l
/
h
) repeatedly to
select a preset station group (A to E) while the
MEMORY indicator is flashing.
The selected preset station group letter appears. Check that the
colon (:) appears in the front panel display.
4
Rotate
M
PROGRAM
(or press
9
PRESET/CH
k
/
n
repeatedly) to select a preset station number (1 to 8)
while the MEMORY indicator is flashing.
• Rotate
M
PROGRAM
rightward to select a higher preset
station number.
• Rotate
M
PROGRAM
leftward to select a lower preset
station number.
5
Press
J
MEMORY
(or
0
MEMORY
) while the
MEMORY indicator is flashing.
The station band and frequency appear in the front panel
display with the preset station group and number you have
selected. The MEMORY indicator disappears from the front
panel display.
• Any stored station data existing under a preset station number is
cleared when you store a new station under the same preset station
number.
• The reception mode (stereo or monaural) is stored along with the
station frequency.
You can exchange the assignments of two preset stations with each
other. The example below describes the procedure to exchange
preset station “E1” with “A5”.
1
Select preset station “E1” using
M
PROGRAM
on
the front panel.
See “Selecting preset stations” on page 70.
2
Press and hold
L
EDIT
for more than 3 seconds.
The MEMORY indicator flashes in the front panel display.
3
Select preset station “A5” using
M
PROGRAM
.
The MEMORY indicator flash in the front panel display.
See “Selecting preset stations” on page 70.
4
Press
L
EDIT
again.
“E1–A5” appears in the front panel display and the
assignments of the two preset stations are exchanged.
Before performing the following operations, set the operation mode
selector on the remote control to
F
SOURCE
and then press
3
TUNER
.
Manual preset tuning
MEMORY
Flashes
MEMORY
A 1 : F M 8 8 . 9 M H z
Preset station group
Flashes
Colon (:)
MEMORY
A 1 : F M 8 8 . 9 M H z
Preset station number
Flashes
Notes
Exchanging preset stations
A 1 : F M 8 8 . 9 M H z
The displayed station has been stored as A1.
MEMORY
E 1 : F M 8 8 . 9 M H z
E D I T
Flashes
MEMORY
A 5 : F M 8 8 . 9 M H z
E D I T
Flashes
A 5 : F M 8 8 . 9 M H z
E 1 - A 5
