Remote control features
125
En
Ad
v
a
nce
d
Op
eratio
n
3
Set the operation mode selector to
G
SOURCE
and
then press an input selector button (
3
) or
5
SELECT
l
/
h
repeatedly to select the control area you want
to customize.
“P-SET” and name of the selected control area appears in the
display window (
4
) alternately.
y
If you want to select “TV”, set the operation mode selector to
F
TV
.
4
Press
9
ENTER
.
The five-digit code set for the selected control area appears in
the display window (
4
).
“00000” appears in the display window (
4
) if no code has been set.
5
Press the numeric buttons (
B
) to enter the
five-digit remote control code for the component you
want to use.
For a complete list of available remote control codes, refer to
“List of remote control codes” at the end of this manual.
y
You can also enter the desired number by pressing
9
k
/
n
/
l
/
h
repeatedly.
6
Press
9
ENTER
to set the number.
“OK” appears in the display window (
4
) if setting was
successful.
“NG” appears in the display window (
4
) if the setting was
unsuccessful. In this case, start over from step 3.
y
If you continuously want to set up another code for another control
area, repeat steps 3 through 6.
7
Press
G
SETUP
again to exit from the setup mode.
8
Press
A
p
or
2
AV POWER
to confirm whether you
can control your component using the remote
control.
y
If operation is not possible and the manufacturer of your component has
more than one code, try each of them until you find the correct one.
• “ERROR” appears in the display window (
4
) on the remote control if you
press a button not indicated in the respective step, or when you press more
than one button simultaneously.
• The supplied remote control does not contain all possible codes for
commercially available audio and video components (including Yamaha
components). If operation is not possible with any of the remote control
codes, program the new remote control function using the learning feature
(see “Programming codes from other remote controls (LEARN)” on
page 126) or use the remote control supplied with the component.
• Functions programmed using the learning mode take priority over remote
control code functions.
• If you set “00012” as the remote control code of the selected control area,
you can operate the currently selected internal source (TUNER, XM,
DOCK, or NET/USB).
Note
P-SET
DVD
04306
SETUP
Notes
