53
English
B
ASIC OPERA
TION
AD
V
ANCED OPERA
TION
APPENDIX
INTR
ODUCTION
PREP
ARA
TION
After this unit has been exposed to a strong external electric shock (such as lightning and strong static electricity) or if you
mishandle the operation of this unit, it may not function properly. In these cases, set this unit in the standby mode, disconnect
the power cord, plug it back in after 30 seconds, and start operating.
TROUBLESHOOTING
FM
AM
26
27
28
26
26
—
■
Tuner
Problem
FM stereo reception
is noisy.
The characteristics of FM stereo broadcasts
may cause this problem when the transmitter is
too far away or the antenna input is poor.
Check the antenna connections.
Try using a high-quality directional FM
antenna.
There is distortion,
and clear reception
cannot be obtained
even with a good FM
antenna.
There is multipath interference.
Adjust the antenna position to eliminate
multipath interference.
The desired station
cannot be tuned in
with the automatic
tuning method.
The station is too weak.
Use the manual tuning method.
Previously preset
stations can no
longer be tuned in.
The unit has been disconnected for a long
period.
Re-store the stations.
The desired station
cannot be tuned in
with the automatic
tuning method.
The signal is weak or the antenna connections
are loose.
Tighten the AM loop antenna connections and
orient it for best reception.
There are continuous
crackling and hissing
noises.
There are buzzing and
whining noises
(especially in the
evening).
Cause
Remedy
Refer to
page
Use an outdoor antenna and a ground wire. This
will help somewhat, but it is difficult to
eliminate all noise.
Noises result from lightning, fluorescent lamps,
motors, thermostats and other electrical
equipment.
A TV set is being used nearby.
Move this unit away from the TV.
Problem
Cause
Remedy
Refer to
page
The remote control does
not work nor function
properly.
Wrong distance or angle.
The remote control will function within a
maximum range of 6 m (20 feet) and no more
than 30 degrees off-axis from the front panel.
Direct sunlight or lighting (from an inverter type
of fluorescent lamp, etc.) is striking the remote
control sensor of this unit.
Reposition the unit.
The batteries are weak.
Replace all batteries with new ones.
The unit or other
component cannot be
controlled.
The component to be controlled has not been
selected.
Press one of the component selector buttons,
corresponding to the component to be
controlled.
The remote control cannot control system
components.
The manufacturer code has not been set up
properly.
Enter the code again.
Try setting another code for the same
manufacturer.
Depending on the manufacturer or the model,
some components cannot be controlled with this
unit’s remote control even though the code has
been set up properly.
Use the original remote control supplied with
your component.
7
7
3
40
—
45
—
■
Remote control
26
Use the manual tuning method.
Use a high-quality directional FM antenna.
Use the manual tuning method.
27
26
27
0110V520/V420_50-58_EN
2/6/1, 2:40 PM
53
