54
En
Troubleshooting
■
Remote control
■
Resetting the system
Use this feature to reset all the parameters of this unit to
the initial factory settings.
1
Press
1
STANDBY/ON
on the front panel to
set this unit to the standby mode.
2
Press and hold
0
TONE CONTROL
and
then press
1
STANDBY/ON
to turn on this
unit.
The advanced setup menu appears in the front panel
display.
3
Press
A
PROGRAM
l
/
h
to select
“PRESET”.
4
Press
B
STRAIGHT
repeatedly to select
“RESET”.
Select “CANCEL” to cancel the initialization
procedure without making any changes.
5
Press
1
STANDBY/ON
to confirm your
selection and set this unit to the standby
mode.
• This procedure completely resets all the parameters of this unit
including the set menu parameters. However, the advanced
setup menu parameters will not be initialized.
• The initial factory settings are activated next time you turn on
this unit.
y
To cancel the initialization procedure at any time without making
any changes, press
B
STRAIGHT
repeatedly to select
“CANCEL” and then press
1
STANDBY/ON
.
Problem
Cause
Remedy
See
page
The remote control
does not work nor
function properly.
Wrong distance or angle.
The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
20
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
Reposition this unit.
—
The batteries are weak.
Replace all batteries.
3
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
Notes
