44
En
Playback
Press
D
MUTE
on the remote control to mute the
audio output. Press
D
MUTE
again to resume
the audio output.
y
• You can also rotate
Q
VOLUME
on the front panel or press
B
/–
on the remote control to resume the audio
output.
• You can adjust the muting level by using the “MUTING TYPE”
parameter in “VOLUME MENU” (see page 81).
• The MUTE indicator flashes in the front panel display when the
audio output is muted and disappears from the front panel
display when the audio output is resumed.
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
1
Set the operation mode selector to
C
AMP
and then press
F
SET MENU
on the remote
control.
The top “SET MENU” display appears in the OSD.
2
Press
3
n
repeatedly to select “SIGNAL
INFO” and then press
3
ENTER
.
The audio information about the input source appears
in the OSD.
3
Press
3
l
/
h
to toggle between the audio
and video information displays.
y
The information is also appears in the front panel display.
Press
3
k
/
n
repeatedly to change the displayed
information.
4
Press
F
SET MENU
on the remote control
again to exit from “SET MENU”.
■
Audio information
• “–––” appears when this unit cannot display the corresponding
information.
• Some high definition audio bitstream contents may not include
the discrete surround back left and right channel signals but are
encoded at the bitrate of 192 kHz.
• Even if you make settings to output bitstreames directly, some
players convert the Dolby TrueHD or Dolby Digital Plus
bitstreams to the Dolby Digital bitstreams, while converting the
DTS-HD Master Audio or DTS-HD High Resolution Audio
bitstreams to the DTS bitstreams.
■
Video information
“–––” appears when this unit cannot display the corresponding
information.
Muting the audio output
Displaying the input source
information (SIGNAL INFO)
[]/[]:
[ENTER]:
[
p
SET MENU
;
AUTO SETUP
;
MANUAL SETUP
;
SYSTEM MEMORY
;
SIGNAL INFO
UP/DOWN
Enter
.
FORMAT
Signal format. When this unit cannot detect a
digital signal, it automatically switches to
analog input.
SAMPLING
The number of samples per second taken from
a continuous signal to make a discrete signal.
CHANNEL
The number of source channels in the input
signal (front/surround/LFE). For example, a
multi-channel soundtrack with 3 front
channels, 2 surround channels and LFE, is
displayed as “3/2/0.1”.
BITRATE
The number of bits passing a given point per
second.
DIALOG
The dialogue normalization level preset to the
current input bitstream signal (see page 125).
FLAG
Flag data encoded in the bitstream, or PCM
signals that cue this unit to automatically
switch decoders (“Surround EX”, etc.).
Notes
HDMI SIGNAL
Type of the source video signals and
the video signals output at the HDMI
OUT jack of this unit.
HDMI RES.
Resolution of the input signal (analog
or HDMI) and the output signal
(HDMI).
ANALOG RES.
Resolution of the source video signals
and the analog video signals output at
the COMPONENT MONITOR OUT
jacks of this unit.
HDMI ERROR
(HDMI MESSAGE)
Error message for HDMI sources or
connected HDMI devices. See
page 120 for details.
Note
