115
En
Advanced setup
AD
V
ANCED
OPERA
T
ION
English
Setting remote control TUNER ID
1
Set the operation mode selector to
C
AMP
or
C
SOURCE
and then press
1
TUNER
on the
remote control to select the tuner to change
the remote control ID.
2
Press and hold
L
LEARN
for about 3
seconds using a ballpoint pen or similar
object until “L;TUN” and “TUNER”
alternately appear in the display window (
A
).
• Be sure to press and hold
L
LEARN
for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 2.
3
Press
3
ENTER
.
The four-digit code set for the selected input area
appears in the display window (
A
) on the remote
control.
4
Press the numeric buttons (
5
) to enter the
four-digit remote control code for the input
area you want to use.
*1 The remote control setting.
*2 The setting of this unit.
5
Press
3
ENTER
to set the number.
“OK” appears in the display window (
A
) if the
setting was successful.
“NG” appears in the display window (
A
) if the
setting was unsuccessful. In this case, start over from
step 2.
6
Press
L
LEARN
again to exit from the setup
mode.
Notes
LEARN
3 seconds
Remote
control
TUNER ID
code
*1
Function
RC TUNER
ID
*2
2602
(initial setting)
Operates this unit using the
default code.
ID1
(initial setting)
2603
Operates this unit using an
alternative code.
ID2
LEARN
