Control functions
10
Odometer and tripmeter modes
Pushing the select/reset button switches the
display between the odometer mode “ODO”
and the tripmeter mode “TRIP”.
To reset the tripmeter, push the select/reset
button for at least one second while the trip-
meter is displayed.
TIP
To switch the speedometer, odometer, and
tripmeter displays between kilometers and
miles, select the odometer mode “ODO”, and
then push the select/reset button for at least
10 seconds while the snowmobile is stopped.
ESU10410
High beam indicator light “
”
The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 13 for headlight beam switch
operation.)
ESU10482
Low coolant temperature indi-
cator light “
”
The low coolant temperature indicator light
comes on when the coolant temperature is
low and informs the rider that the snowmobile
should be warmed up. After the engine is
started, warm it up until the indicator light
goes off.
The snowmobile can be operated normally af-
ter the indicator light goes off.
TIP
Drive the snowmobile at low speeds when the
low coolant temperature indicator light is on. If
the engine speed is too high, the warning light
and self-diagnosis warning indicator will flash
and the two-digit code “86” will flash in the trip-
meter/odometer display. When this occurs,
maximum engine speed is reduced to protect
the engine.
ESU10424
Fuel meter and grip/thumb
warmer level indicator
The fuel meter and grip/thumb warmer level
indicator have eight segments which show
the amount of fuel remaining in the fuel tank,
the grip warmer level, or the thumb warmer
level.
1. High beam indicator light “
”
1. Low coolant temperature indicator
light “
”
2. Warning light “
”
3. Self-diagnosis warning indicator “
”
4. Two-digit code “86”
U8ET14E0.book Page 10 Thursday, April 10, 2008 9:47 AM
