6
Output channel operations
58
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual
Operating section
Hint
The detection point (metering point) of the signal levels shown
in the meters can be changed if desired. For details, refer to
p.109.
❏
Sending signals from MIX channels to
MATRIX buses
Here’s how a signal sent from an input channel to a MIX
bus can be output to a MATRIX bus. This can be done
either by specifying the send level sent from all MIX chan-
nels to a specific MATRIX bus, or by specifying the send
level sent from a specific MIX channel to all MATRIX
buses.
To send signals from all MIX channels to a
specific MATRIX bus
1
Make sure that appropriate signals are being
sent from input channels to the MIX buses.
2
Repeatedly press the [MATRIX/ST] key of the
DISPLAY ACCESS section to access the
MATRIX/ST ROUTING screen shown below.
3
Use the left/right scroll bar to display the MIX
channel that you want to send to the MATRIX
bus, and click the MIX TO MATRIX ON/OFF
button to turn it on.
The signal of the corresponding MIX channel is now
sent to the MATRIX bus.
Hint
You can use the PRE FADER/POST FADER buttons in the
MIX TO MATRIX area to change the send point (pre-fader/
post-fader) of the signal sent from the MIX channel to the
MATRIX bus.
4
Press the [MIX MASTER] key in the MIX
section.
5
Press and hold the MATRIX [SEL] key for the
send-destination MATRIX bus.
All MIX [SEL] keys will blink. As long as you hold
down the MATRIX [SEL] key, the MIX encoders 1–24
will respectively adjust the send levels from the MIX
channels to the currently selected MATRIX bus.
6
Continuing to hold down the MATRIX [SEL]
key, turn MIX encoders 1–24 to adjust the level
of the signal sent from each MIX channel to
the currently selected MATRIX bus.
The LEDs around the periphery of the MIX encoder
indicate the approximate level. When you take your
hand off the MATRIX [SEL] key, the encoders will
revert to their previous function.
Hint
You can fix the encoders in the above state by rapidly press-
ing the MATRIX [SEL] key twice. To return to the previous
state, press any MIX [SEL] key or MATRIX [SEL] key.
To send from a specific MIX channel to all
MATRIX buses
1
Make settings so that a signal is sent from the
desired MIX channel to a MATRIX bus, as
described in steps 1–3 of “To send signals from
all MIX channels to a specific MATRIX bus.”
2
Press the [MIX MASTER] key in the MIX
section.
3
Press and hold the MIX [SEL] key for the send-
source MIX channel.
All MATRIX [SEL] keys will blink. As long as you con-
tinue to hold down the MIX [SEL] key, MATRIX
encoders 1–8 will adjust the send levels sent from the
selected MIX channel to each MATRIX bus.
4
Continuing to hold down the MIX [SEL] key,
turn MATRIX encoders 1–8 to adjust the level
of the signal sent from the currently selected
MIX channel to the MATRIX buses.
The LEDs around the periphery of the MATRIX
encoder indicate the approximate send level. When
you take your hand off the MIX [SEL] key, the encod-
ers will revert to their previous function.
MIX channels
MIX TO MATRIX
ON/OFF buttons
MATRIX/ST ROUTING
Use the encoders of the MIX section to
adjust the send levels
