PM1D System Software V1.6 Supplementary Manual
26
•
OUT CH VIEW function CH COPY screen
•
ALL
.................. All parameters except for NAME
•
EQ
................... EQ function settings
•
COMP
............. COMP function settings
•
DELAY
............ DELAY function settings
•
FADER
............ Fader level
•
ON
................... [ON] switch on/off status
•
BAL
................. Balance setting (valid only for STE-
REO A/B channels or paired MIX/
MATRIX channels)
•
INSERT
........... Insert on/off and insert position
•
TO MTRX
....... Send level to the specified MATRIX
buses (valid only for STEREO A/B
channels or MIX channels)
•
DCA
................ DCA groups to which the channel
belongs
•
MUTE
............. Mute groups to which the channel
belongs
•
LCR
................. Settings of the LCR screen
•
NAME
............. Name of the output channel
Hint
•
If a MIX channel or STEREO A/B channel is
selected and the TO MTRX button is turned on,
use the MATRIX area at the right to select the des-
tination MATRIX bus(es).
•
If you click the ALL button, all parameters except
for NAME will be selected. At this time, all MIX
buses will be selected for the TO MTRX parameter.
Only if you select a MIX channel in the OUT CH
VIEW function CH COPY screen, and turn on the
ALL button, will you also be able to choose whether
send levels for signals sent from input channels to the
MIX bus will be copied as well. To make this setting,
use the following two buttons located at the left of
the ALL button.
•
WITHOUT MIX SEND button
If this button is on, the send level of signals sent from
each input channel to the corresponding MIX bus
will not be copied.
•
WITH MIX SEND button
If this button is on, the send level of signals sent from
each input channel to the corresponding MIX bus
will be copied as well.
Since not only the settings of the MIX channel but
also the send levels from the input channels to the
MIX bus will be copied completely, this is convenient
when you want to change the MIX bus you are using.
4. In the DESTINATION CH SELECT area, select the
copy-destination channel(s).
Buttons for the copy-source channel and for chan-
nels of a type differing from the copy-source channel
will be grayed-out, and cannot be selected. However
as an exception, it is possible to copy between two
paired input channels and a ST IN channel.
Hint
By clicking the SET ALL button you can select all
items. By clicking the CLEAR ALL button you can
de-select all items.
5. To execute the copy, click the COPY
→
button
located in the center of the screen.
