ENGLISH
19
Editing VL Voice Part Parameters
ScrCtrlDpt (Scream Control Depth) ....................................... Settings: -64 … +63
Sets the amount of variation produced by the controller assigned to scream. The higher
the value the greater the variation. Positive values cause an increase in scream effect in
response to higher controller values (e.g. increased breath pressure or higher modula-
tion wheel position), while minus values cause a decrease in scream effect in response
to higher controller values.
6. Breath Noise
Bnz CC No. (Breath Noise Control Change Number) .... Settings: off … 95, AT, VEL, PB
“Breath Noise” can be used to add the required amount of breath noise to a voice. The
“Bnz CC No.” parameter specifies the controller to be used for breath noise control.
When set to “off” no breath noise variation can be produced via a controller, but a
continuous breath noise value is determined by the “BnzCtrlDpt” parameter, below
(negative values increase the breath noise level).
BnzCtrlDpt (Breath Noise Control Depth) ............................. Settings: -64 … +63
Sets the amount of variation produced by the controller assigned to breath noise. The
higher the value the greater the variation. Positive values cause an increase in breath
noise in response to higher controller values (e.g. increased breath pressure or higher
modulation wheel position), while minus values cause a decrease in breath noise in
response to higher controller values.
