PJP-EC200 Setup Procedure
5
7.
Connect the power cable to an AC outlet.
8.
Configure the DIP switch settings.
1) Set the DIP switch
⑥
(SETTING) to “DIP SW” to enable the DIP switch
settings.
2) When using a condenser microphone, set the DIP switch
①
(PHANTOM) to
“ON” to supply 48V power to the microphone.
3) Set the DIP switch
②
(IN1 & 2) to “MIC” to select the MIC level for
MIC/LINE INPUT.
4) Set the DIP switch
③
(CONF.OUT) to “MIC” to select the MIC level for
CONFERENCE OUT.
5) When using a fixed microphone such as a gooseneck microphone and a
boundary microphone, set the DIP switch
④
(EC TYPE) to “1” (Echo
canceller settings: “Level: 3, Mic Type: Fixed Mic”).
When using a tie-pin microphone or a handheld microphone, set the DIP
switch
④
(EC TYPE) to “2” (Echo canceller settings: “Level: 5, Mic Type:
Hand Mic”).
6) Set the DIP switch
⑤
(MIX&FS) to “OFF” to disable the public-address
system.
9.
Turn on the external devices.
10.
Turn on this unit.
11.
Adjust the speaker level of your PC or webconference system.
1)
Make sure the external device connected to CONFERENCE IN/OUT is
DIP switch
