Yamaha Phazer Venture Lite PZ50GTA 2011, Supplementary Service Manual

Page: 53 / 78

SPEC
43
PZ50VTA
Connect the branch line of the
oil pressure sensor and oil pres-
sure switch to the oil pressure
sensor and oil pressure switch
in the engine section.
Clamp the oil pressure sensor
lead, oil pressure switch lead,
and throttle position sensor lead
the frame front cross member
with the clamp.
Fuel hose
Injector sub-wire harness cou-
pler
Fasten the fuel hose with the
hose clip. Face the ends of the
hose clip outward, angled 45°
downward.
Rectifier/regulator
Collar
Wire harness
Speed sensor coupler
Auxiliary DC outlet
Clamp the auxiliary DC outlet
lead, fuel tank breather hose,
and speed sensor lead to the
frame rear cross member with
the clamp. For routing, order
insignificant.
Clamp the speed sensor lead
and fuel tank breather hose to
the frame rear cross member
with the clamp. For routing,
order insignificant.
Hose protector
Drive guard
Clamp the speed sensor lead
and fuel tank breather hose with
a clamp. For routing, order
insignificant.
Clamp the speed sensor lead
and fuel tank breather hose with
the lead holder (be sure to bend
the holder so that the lead and
hose will not come loose). For
routing, order insignificant.
Clamp the speed sensor lead
with the lead holder (be sure to
bend the holder so that the lead
and hose will not come loose).
For routing, order insignificant.
Cylinder identification sensor
Ignition coil
To the handlebar switch
Frame rear cross member Ground lead
To the auxiliary DC jack
To the speed sensor
Align the paint mark on the fuel
tank breather hose with the top
of the grommet. During installa-
tion, soapy water may be
applied to the grommet hole.
CABLE ROUTING