Yamaha Phazer Venture Lite PZ50GTA 2011, Supplementary Service Manual

Page: 43 / 78

SPEC
33
CABLE ROUTING
PZ50GTA, PZ50RTA, PZ50MTA
To the coolant temperature sen-
sor
To the knock sensor
Pass the fuel hose over the wire
harness and fuel tank breather
hose.
Bundle the slack in the right
handlebar switch leads and fas-
ten it with the clamp.
To the oil level switch
Pass the fuel pump lead over
the wire harness and fuel tank
breather hose.
Clamp the wire harness, park-
ing brake cable, and brake hose
to the frame rear cross member
with the clamp.
Clamp the wire harness and
fuel tank breather hose to the
frame rear cross member with
the clamp.
Spring
To the brake
Throttle cable
Throttle cable protector
To the tail/brake light
Fuel hose
Clamp the fuel pump lead at the
positioning tape to the fuel hose
with the clamp.
Clamp
To the meter
Install the fuel tank breather
hose to the fuel tank with the
hose clamp. Be sure to connect
the hose end that does not have
a paint mark to the fuel tank.
Parking brake cable
Brake hose
Route the fuel tank breather
hose along the frame rear cross
member.
Tighten the rectifier/regulator
securing flange nut together
with the ground lead.
Rectifier/regulator
Connect the wire harness side
coupler (black) to the rectifier/
regulator.
AC magneto lead coupler
Fuel sender coupler
Headlight coupler
Route the intake air pressure
sensor coupler behind the throt-
tle cable on the rear of the
snowmobile (so that the coupler
with white tape is positioned on
the left side.)
Route the intake air tempera-
ture sensor coupler further to
the right of the snowmobile than
the throttle cable.
CABLE ROUTING