PERIODIC MAINTENANCE AND ADJUSTMENT
7-28
7
3. Fully charge the battery before in-
stallation.
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals and
that the breather hose is properly
routed, in good condition, and not
obstructed.
ECA10600
NOTICE
_
If the breather hose is positioned in
such a way that the frame is ex-
posed to electrolyte or gas expelled
from the battery, the frame could
suffer structural and external dam-
ages.
_
EAUU0541
Replacing the fuse
The fuse is located behind panel A.
(See page 7-7 for removing proce-
dure.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn off
all electrical circuits.
2. Pull the battery out. (See page 7-26
for checking the electrolyte level/re-
moving-installing battery.)
3. Pull the starter relay out.
4. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
ECA10640
NOTICE
_
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
_
5. Place the starter relay into the
original position.
6. Install the battery to the vehicle.
1. Starter relay
ZAUU0333
1. Fuse
2. Spare fuse
Specified fuse:
10 A
1
1
1
2
2
ZAUU0334
E_1P7F8199E2.book Page 28 Tuesday, January 27, 2009 10:29 AM
