MENU DESCRIPTION
Repressing A & B buttons while the NXAMP is starting (this last 2 seconds). At the end of
the boot time, the above screen should appear, while the amplifier part itself starts up (this
last around 18 seconds, and ends when you hear the output relays moving and see the
“Amp Protect” LED shutting down). Please note that you don’t need to wait for the
amplifier to start for choosing your cabinet setup.
You should then see the two up and down arrows surrounded in the above drawing. This
means that you can change the speaker setup by turning the wheel. Select the appropriate
setup by pressing “OK” (button B) or press the button A to go back to current setup
without changes.
N.B.: You can reset the unit without powering off by simultaneously repressing buttons A,
B & SELECT CH1 at the same time for at least 3 seconds.
N.B.: The setup number is blinking when the currently displayed setup is different from the
one running into the DSP at the moment.
Note: Selecting a new family will set all parameters to factory default settings.
N.B.: The setup number 0 “FLAT –NO PROTN.” is the default setup; it means no EQ (Flat)
and no protection (No protn.) for the speakers but of course amplifier protections will still
work.
Adjusting Volume
The volume of each channel can be adjusted from the Volume menu (unit is dB). Bellow is
a picture of this menu.
PAGE 39 OF 91
