Yamaha MXT9L 2019, Manual

Page: 49 / 116

Instrument an d control functions
4-31
4
4. Insert the accessory plug into the
auxiliary DC jack.
5. Turn the main switch on, and start
the engine. (See page 6-2.)
6. Turn the accessory on.
WARNING
EWA14361
To prevent electrical shock or short-
circuitin
g , make sure that the cap is
installe d when the auxiliary DC jack
is not b ein g use d .
EAU70641
Auxiliary DC connector
This vehicle is equipped with an auxil-
iary DC connector. Consult your
Yamaha dealer before installing any
accessories.
EAU15306
Si d estan d
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
EWA10242
The vehicle must not b e ri dd en with
the si d estan d d own, or if the si d e-
stan d cannot b e properly move d up
(or d oes not stay up), otherwise the
si d estan d coul d contact the g roun d
an d d istract the operator, resultin g
in a possi b le loss of control.
Yamaha’s i g nition circuit cut-off
system has b een d esi g ne d to assist
the operator in fulfillin g the respon-
si b ility of raisin g the si d estan d b e-
fore startin g off. Therefore, check
1. Auxiliary DC jack
1
UBD511E0.book Page 31 Friday, September 13, 2019 11:39 AM