Yamaha MT07M, Owner'S Manual

Page: 62 / 108

Perio d ic maintenance an d a d justment
7-13
7
8. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
9. Refill with the specified amount of
the recommended engine oil.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
ECA11621

In or d er to prevent clutch slip-
pa g e (since the en g ine oil also
lu b ricates the clutch), d o not
mix any chemical a dd itives. Do
not use oils with a d iesel speci-
fication of “CD” or oils of a hi g h-
er quality than specifie d . In
a dd ition, d o not use oils la b ele d
“ENERGY CONSERVING II” or
hi
g her.

Make sure that no forei g n mate-
rial enters the crankcase.
10. Check the O-ring for damage, and
replace it if necessary.
11. Install and tighten the engine oil
filler cap.
12. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
TIP
After the engine is started, the engine
oil pressure warning light should go off.
1. Torque wrench
Ti g htenin g torque:
Oil filter cartridge:
17 N·m (1.7 kgf·m, 13 lb·ft)
Ti g htenin g torque:
Engine oil drain bolt:
43 N·m (4.3 kgf·m, 32 lb·ft)
1
Recommen d e d en g ine oil:
See page 9-1.
Oil quantity:
Oil change:
2.30 L (2.43 US qt, 2.02 Imp.qt)
With oil filter removal:
2.60 L (2.75 US qt, 2.29 Imp.qt)
1. Engine oil filler cap
2. O-ring
2
1
UBAT10E0.book Page 13 Friday, November 6, 2020 6:08 PM