Perio
d
ic maintenance an
d
a
d
justment
7-38
7
2. Insert the wheel axle from the right
side.
3. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
4. Install the brake calipers and the
reflectors by installing the bolts.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
5. Install the brake hose holder by in-
stalling the bolt.
6. Tighten the brake caliper bolts and
the brake hose holder bolt to the
specified torques.
7. Tighten the wheel axle, and then
the wheel axle pinch bolt to the
specified torques.
8. Push down hard on the handlebar
several times to check for proper
fork operation.
EAU44802
Rear wheel (for non-ABS
mo
d
els)
WARNING
EWA14841
For the ABS mo
d
el, have a Yamaha
d
ealer remove an
d
install the wheel.
EAU59942
To remove the rear wheel
WARNING
EWA10822
To avoi
d
injury, securely support the
vehicle so there is no
d
an
g
er of it
fallin
g
over.
1. Loosen the locknut and drive
chain slack adjusting nut on each
side of the swingarm.
2. Loosen the axle nut.
Ti
g
htenin
g
torques:
Brake caliper bolt:
40 Nm (4.0 m·kgf, 29 ft·lbf)
Brake hose holder bolt:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Ti
g
htenin
g
torques:
Wheel axle:
65 Nm (6.5 m·kgf, 47 ft·lbf)
Front wheel axle pinch bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
U1WS2AE0.book Page 38 Monday, December 7, 2015 2:00 PM