MonitorMix User Guide
7
6.
Select [DHCP] or [Static] (static IP address).
Configure the following settings when selecting Static.
IP Address
Enter an IP address that only changes the fourth octet of the IP address of the mixer.
(For example, if the IP address for the mixer is “192.168.0.128”, enter an IP address like “192.168.0.
127
” for the smart
device.)
Subnet Mask
255.255.255.0
Router
Enter the IP address for the Wi-Fi access point
Typically this is printed on a label on the device itself or is listed in the device’s manual.
DNS
Enter the IP address for the Wi-Fi access point
NOTE
•
You can check the static IP address set on the mixer on the mixer SETUP screen or NETWORK screen.
•
For a CL/QL series console, you can only set the static IP address. If you select DHCP to connect to Wi-Fi, set the range of IP addresses that the DHCP server or
the Wi-Fi access point assigns so that the IP address set for the CL/QL series is included in the same subnet. (For example, if the IP address of the CL/QL series is
192.168.0.128, set the range of DHCP from 192.168.0.2 to 192.168.0.127.)
•
The static IP address of each connected device should be set a unique IP address.
7.
Press the Home button to close the [Settings] menu.
NOTE
•
Make sure that the same subnet is set for the IP address as that set for the mixer unit.
•
If DHCP settings cannot be applied after performing step 5 above, check the settings for the DHCP server in use. You can also use a static IP address and configure
OS settings.
