Yamaha MG206c-USB, Service Manual

Page: 43 / 121

MG206C-USB/MG206C
43
L
R
MONITOR OUT L
+16
±
3 dBu
-
MONITOR OUT R
L
R
INPUT CH1 PAN control
PHONE
(INSERT)
1
INPUT
LEVEL
-20 dBu
L (turned counterclockwise fully)
R (turned clockwise fully)
-
+16
±
3 dBu
* Set the 2TR IN level control to Maximum.
* Set the STEREO level control to Minimum.
* Set the sound control of the personal computer to Maximum.
* Turn the TO STEREO/TO MONITOR switch to ON (TO MONITOR) position.
3. Others
3-1 PHANTOM
Connect a 10 k
Ω
load resistance between pin 1 and pin 2 of the INPUT A or MIC terminal and short-circuit pin 2 and pin 3.
Then turn on the PHANTOM switch and check the PHANTOM indicator lights up and the voltage between pin 1 and pin 2 is
b33 V and +37 V.
4. Settings for shipping
4-1 Factory Settings
• Equalizer gain control (HIGH, MID, LOW) : Center (0)
• PAN, PAN/BAL, BAL control : Center
• Other VR controls : Minimum
• Faders : Minimum
• Lock-push switches : OFF
• ON/STANDBY switch (on rear side) : STANDBY
2-18-2 GAIN
Playback the recorded file via USB, and then check the output level obtained at the MONITOR OUT L/R terminals is within the
range specified in the table 2-18-2.
Table 2-18-2
2-18 USB (MG206C-USB)
2-18-1 Recording
With the condition specified in the table 2-18-1, record the output signal on the personal computer via USB.
Table 2-18-1