16
Battery bracket
Installation: Inspection And
Adjustment After Installing
Inspection Points and
Adjustment Points
3. Adjust the direction of the warning light
(LED).
Turn the warning light with your finger until it
can be easily seen when sitting in the wheel-
chair.
✽
This is attached to the left wheel.
4. Adjust the angle of the battery.
If the battery is sharply tilted, it is difficult to
remove it.
Procedure 1) Remove the right wheel.
2) Remove the plate cover. (2
screws)
3) Remove the 3 screws of the
battery fitting plate.
4) Shift the position of the bat-
tery fitting plate by discon-
necting the largest connector.
5) Change the position by re-
moving the three battery
bracket fixing bolts.
CAUTION:
Tighten with the tightening torque specified
on page 4.
5. Adjust the length of wire harness.
If the wire harness is loose, pull it inside the
cover and clip it with the supplied clamp
(90465-10098).
CAUTION:
Be careful not to tighten the clamp exces-
sively, causing bending.
Battery bracket
