8
Installation: Preparation
1. Angle adjustment of the battery bracket
If the battery box is sharply tilted when the
wheel assembly is installed, remove the
three bolts indicated by the arrows, and
straighten the battery box.
2. Adjustment of the main switch length
and angle
Adjust the level position until the switch le-
ver button is easy to operate, when doing
this, adjust the positioning of the wires as
well.
3. Adjustment of the stoppers
At delivery, the stoppers are installed in po-
sition 2 for the left and position 4 for the
right. For the sports type, change the stop-
per positions to position 1 for the left and po-
sition 6 for the right.
NOTE:
Apply thread lock to the threaded portions of the
stoppers and tighten with the specified tighten-
ing torque.
4. Position of the clamp bracket
The installed clamp bracket is shown in the
figure as the standard type, with the insert
inlet of stopper located at the back pipe front
side.
Installation Based on
Wheelchair Type
Main switch
Right side
Left side
Right side
Left side
Stopper