PREPARATIONS
➤
Placing speakers
En
14
3.1-channel system
2.1-channel system
■
Setting the speaker impedance
(U.S.A. model only)
Under its default settings, the unit is configured for 8-ohm speakers. When connecting
6-ohm speakers, set the speaker impedance to “6
Ω
MIN”. In this case, you can also
use 4-ohm speakers as the front speakers.
1
Before connecting speakers, connect the power cable to an AC wall
outlet.
2
While holding down STRAIGHT on the front panel, press
z
(power).
3
Check that “SP IMP.” is displayed on the front display.
4
Press STRAIGHT to select “6
Ω
MIN”.
5
Press
z
(power) to set the unit to standby mode and remove the
power cable from the AC wall outlet.
You are now ready to connect the speakers.
1
2
3
9
1
2
9
z
(power)
STRAIGHT
SPIMP.8MIN
1
Speaker placement
2 3 4 5 6 7 8 9 10
Summary of Contents for HTR-5065
